I have the Taig CNC mill in place and firmly mounted.
The mill is now bolted to the bench with three 1/4-20 x 1.5 in. SS bolts (SS to prevent rusting). That is a commercial “bun” pan under the mill. Overall dimensions of the pan are 18×26. I don’t expect the pan to get all the swarf but it will help contain some of the oil and mist coolant when used.
I found what I call “panduit” in a very small size. I mounted it on the back wall to help heep the CNC motor leads up out of the… Continue reading
I got the CNC mill to cut the entire loco driver last night. The rough cut looked great. I included a finish pass in the code but using the same flat 1/8″ mill bit. Not so good there. Not yet ready for prime time. I also need to buy some solid wood for test blocks. I have been using multi-layer exterior plywood which is good for seeing the depth of each pass, but it splinters too easily.
I would also love to try wax. I have a sample. I may order a larger block and cut it into layers. Better… Continue reading
Many months ago I designed a perfect drawing of the A3 locomotive driver and is one of the “driving” reasons for me to set the Micro CNC mill into operation. I ran my first output code on a wood block last Sunday and it was a disaster! The mill ran fine but the cutting was awful.
I ran the compiler again last night and produced another machine code… Continue reading
I got the backboard installed today. The afternoon was bright and sunny and the temp was cool. Somewhere in the 80’s. Just right for working in the shop.
The white material is available a Lowe’s. It seems to me mostly a plastic but somewhat like Linoleum. I was able to cut it with large sheet metal shears. It is attached with liquid nails. The corners are caulked. The material has a pebbly but shiny surface.
In the store Lowe’s built a booth using this material. It is where they wet cut ceramic floor tiles. It is holding up very well… Continue reading
I spent most of the late morning and early afternoon today getting the bits and pieces working again for the Taig Micro-Mill CNC setup. The configuration layout has changed since I built a new bench in a new location in the workshop. I also fiddled quite a bit with the electrical and software set-up. It is at a point where it can again do some CNC work.
The Taig Micro-Mill is still fine shape after it’s leap to the floor in the “Great Wreck (GW)”. I have the new ER 16 spindle on it now. This is a micro-mill and… Continue reading