I know most of my readers like action shots. Here are a few to keep the juices flowing. It’s just one very tiny step in the making of parts, but there is a bit of interesting machine set up going on here.
I had to cut a 3/32″ wide x 45 deg. chamfer on the one end of both of the two brackets I made for the tender steps. That doesn’t sound like much of a job, does it?
I priced 45 degree end mills and after I got back off the floor, I decided that wasn’t… Continue reading
I made one part (#10) two pieces last weekend. I milled a 1/2″ square bar of brass into a 1/8″ x 1/2″ angle. It is to be used for the brackets to hold the tender steps. I got the milling done just fine. Then…
I reached around the X3 mill, I think to turn off the main power. It felt like I got stabbed in the back. I have a bad vertebra at the bottom of my spine. Years of heavy lifting destroyed the padding. Occasionally I get an extreme pain spasm and this was one of them.
That shut… Continue reading
I have a decision I should make about building live steam locomotives. It’s not one I have to make but not making it is a decision in itself. In other words I am not at a stopping point where I have to make a decision to move on, but rather shall I continue where I am going or change direction. It is not a dilemma as none of the choices are truly unsatisfactory.
I was taken away from the Pennsy A3 locomotive build for a number of reasons. 9/23/07 is the date of the last update. That’s almost three years ago. Time goes too fast.
No, I wasn’t doing a Rip Van Winkle. I got the HB2 CHC router completely built and operational. I put a DRO on the X3 mill. I made a lot of router projects. A lot of personal and family events occurred in these last three years as exciting as a first grandchild and as serious as a major cancer cure for wife Gloria.
The A3 is not… Continue reading
Yep, see… I’m working on it. I picked a hot day. The shop thermometer hit 101. I worked in the breeze of a fan all day. It was still HOT! I did get the steps finished after exactly 35 months. Yeah, months.