I got the backboard installed today. The afternoon was bright and sunny and the temp was cool. Somewhere in the 80’s. Just right for working in the shop.
The white material is available a Lowe’s. It seems to me mostly a plastic but somewhat like Linoleum. I was able to cut it with large sheet metal shears. It is attached with liquid nails. The corners are caulked. The material has a pebbly but shiny surface.
In the store Lowe’s built a booth using this material. It is where they wet cut ceramic floor tiles. It is holding up very well… Continue reading
I spent most of the late morning and early afternoon today getting the bits and pieces working again for the Taig Micro-Mill CNC setup. The configuration layout has changed since I built a new bench in a new location in the workshop. I also fiddled quite a bit with the electrical and software set-up. It is at a point where it can again do some CNC work.
The Taig Micro-Mill is still fine shape after it’s leap to the floor in the “Great Wreck (GW)”. I have the new ER 16 spindle on it now. This is a micro-mill and… Continue reading
This is the project I have been working on all day. On Labor Day I was laboring my… um… you know, off! I also pulled in the power outlets below the circuit box and the one to the far right. The duplex outlets are fed with 220 volts split to each side with GFI outlets for each phase. This is in the garage so GFI is code. The outlet to the far right is 220 volts with a special plug. Its for my new saw, but I also have a special plan for Christmas lights this year. More on that… Continue reading